Studies show that generally demand for electricity is driven largely by temperature. Heating demand in the winter and cooling demand (air conditioners) in the summer are what primarily drive the seasonal peaks in most regions. Heating degree days and cooling degree days help measure energy consumption by referencing the outdoor temperature above and below 65 degrees Fahrenheit, a commonly accepted baseline.
†Offer is available to Texas residential customers who enroll using the Promotion Code “NIGHTSFREE”. Plan bills a monthly Base Charge, an Energy Charge, and passes through Utility Transmission and Distribution delivery charges. Energy Charges for usage consumed between 9pm and 7am each day is credited back on your bill. The utility charges, including delivery charges for night time hours, are passed through at cost and aggregated on your bill. See Electricity Facts Label for details.
Although conventional long-term contracts may offer you very low kilowatt-hour prices, these contracts also impose many obligations and hefty penalties for non-compliance. No deposit electric plans tend to have a slightly higher energy price that long-term contracts, but allow more freedom in how you pay for your electricity. The most relevant differences between no deposit electricity plans and conventional contracts are summarized in the following table:
Since consumer demand directly affects energy rates, it’s important to note seasonal trends of demand throughout the year. Overall, demand tends to be higher during the winter and summer months and lower during the fall and spring months. This pattern isn’t shocking since it’s normal for people to require more energy during extreme heat and extreme cold.
Most common distribution network and generation is done with 3 phase structures, with special attention paid to the phase balancing and resulting reduction of ground current. It is true for industrial or commercial networks where most power is used in 3 phase machines, but light commercial and residential users do not have real-time phase balancing capabilities. Often this issue leads to unexpected equipment behavior or malfunctions and in extreme cases fires. For example, sensitive professional analogue or digital recording equipment must be connected to well-balanced and grounded power networks. To determine and mitigate the cost of the unbalanced electricity network, electric companies in most cases charge by demand or as a separate category for heavy unbalanced loads. A few simple techniques are available for balancing that require fast computing and real-time modeling.
On the other hand, month-to-month variable rate (no-contract) plans don’t have cancellation fees. You won’t be penalized if you find a better deal elsewhere and want to make another switch. And, you won’t be stuck paying more than you should be if the market rate for electricity trends down. But, if it goes up, you’ll be paying more than your in-contract neighbors, and you’ll likely want to shop around again for a better deal.
Technology that now allows smaller quantities of power to be generated closer to the end-users at prices not too much higher than grid-based power are undermining those economies of scale. More efficient turbines, for example, allow large power users like cement plants and petrochemical factories to come off the grid. Today the limiting factor for large companies to come off the grid often isn’t the efficiency of the power generation technology, but the lack of easy availability of fuel, such as gas or coal to power these turbines Even this problem is being solved by innovations like mini-liquefied natural gas projects.
Wind and solar power are non-dispatchable. Such power is normally sold before any other bids, at a pre-determined rate for each supplier. Any excess is sold to another grid operator, or stored, using pumped-storage hydroelectricity, or in the worst case, curtailed. Curtailment could potentially significantly impact solar power’s economic and environmental benefits at greater PV penetration levels. Allocation is done by bidding.
Knowing how much electricity you use each month is important to finding the cheapest electricity plan. For Houstonians, usage is typically the lowest in the winter and highest in the summer. Your specific usage levels can be determined by simply looking back at previous electric bills and finding the kWh used. To avoid electric bill surprises during the peak summer months, you’ll need to accurately know your peak electricity usage which typically occurs in August.
After Senate Bill 7 went into effect in January 2002, nearly 6 million power customers became eligible to choose their energy supplier. That number has grown through the years. By deregulating the state’s energy market, the Texas Senate gave constituents the power to choose. The process of energy deregulation in Texas dismantled the utilities’ monopoly over the electric market and encouraged customers to explore their energy options.
2. Fraud: Too many people have been victimized by glib sales reps with promises of cheap electricity flowing in an unending stream only to discover that, as is so often true, “it ain’t necessarily so”. They’ve been locked into unwanted term contracts or there’s a catch – some utilities will give you the great rate only if you meet a usage minimum; basically, the “rate” is, in actuality, a “bulk purchase” discounted fee – or they paid a deposit never to hear from the rep again.
Another unwelcome side effect of not knowing your average monthly kWh usage level is that you may end up paying more than you expect. This can occur when a customer inadvertently shops an electric rate based on a higher usage level than they actually use. Electricity suppliers commonly advertise their electric rates associated with the highest (2000 kWh) usage levels since those tend to be the lowest rates.
Short-term prices are impacted the most by weather. Demand due to heating in the winter and cooling in the summer are the main drivers for seasonal price spikes. In 2017, the United States is scheduled to add 13 GW of natural-gas fired generation to its capacity. Additional natural-gas fired capacity is driving down the price of electricity, and increasing demand.
When you’re choosing a new energy deal, think about whether to go for dual fuel (where you get both your gas and electricity from the same company) or separate tariffs (where you get gas from one company, and electricity from another). It’s worth checking both options, as the combined price of separate tariffs can sometimes be less than a dual fuel offer.
Ironically, technology can make the utilities’ problem worse, not better—at least in the short term. In the past, grids were developed because it was cheaper to generate large quantities of power and distribute it over wide distances, rather then generate smaller quantities closer to the place of use. It is for this reason that electricity is seen as a business that benefits from “economies of scale”.
Residential and business consumers in deregulated energy markets have the power to choose their energy supplier. The power to choose gives consumers the opportunity to compare suppliers and find energy plans that satisfy their usage needs and budget requirements. Whether in a deregulated city in Texas, New York, Ohio or another state, you can shop for electricity or natural gas and find the best plan for you!