Wind and solar power are non-dispatchable. Such power is normally sold before any other bids, at a pre-determined rate for each supplier. Any excess is sold to another grid operator, or stored, using pumped-storage hydroelectricity, or in the worst case, curtailed. Curtailment could potentially significantly impact solar power’s economic and environmental benefits at greater PV penetration levels. Allocation is done by bidding.
Although conventional long-term contracts may offer you very low kilowatt-hour prices, these contracts also impose many obligations and hefty penalties for non-compliance. No deposit electric plans tend to have a slightly higher energy price that long-term contracts, but allow more freedom in how you pay for your electricity. The most relevant differences between no deposit electricity plans and conventional contracts are summarized in the following table:
Most common distribution network and generation is done with 3 phase structures, with special attention paid to the phase balancing and resulting reduction of ground current. It is true for industrial or commercial networks where most power is used in 3 phase machines, but light commercial and residential users do not have real-time phase balancing capabilities. Often this issue leads to unexpected equipment behavior or malfunctions and in extreme cases fires. For example, sensitive professional analogue or digital recording equipment must be connected to well-balanced and grounded power networks. To determine and mitigate the cost of the unbalanced electricity network, electric companies in most cases charge by demand or as a separate category for heavy unbalanced loads. A few simple techniques are available for balancing that require fast computing and real-time modeling.
Payless Power provides the best prepaid and standard energy plans with no cancelation fees and no deposit in the area. Since 2005, Payless Power has been helping people get better energy rates and save money on their average power bill, regardless of income or credit history. As a family-owned energy provider and not one of the giant electricity suppliers, we take great pride in serving our customers with care and respect.
When it comes to pinpointing specific months rather than seasons, every part of the country has its own highest- and lowest-demand months. For example, hotter states, such as Texas, have their lowest demand anytime between December and March. When it comes to your own location, you can determine typical demand trends by taking a look at your area’s weather patterns or your billing records that showcase your personal monthly demand levels.
There was a time when electricity was electricity. Like so many other places around America, in Houston, electricity didn’t mean “cheap electricity”. But you moved into your home and you called the utility and they turned on the power and the bill came in and you paid it every month. Oh, sure, you might grumble at the amount but then you’d go around and yell at the kids for leaving the lights on and the TV blaring with nobody in the room or maybe you’d look into buying more energy-efficient appliances. When it came down to it, the Bill was the Bill. Either you paid the bill or you ate dry packet meals, had cold showers, and watched TV by peering through the neighbor’s window after dark (preferably once they’d turned the TV on). What’s that? You want cheap electricity? Sure thing: call 1-800-WHO-CARES any time during regular business hours of 2:17am to 3:04am Sundays only.
Anyone on a standard rate tariff is at risk of seeing rising energy bills – so one of the best ways to protect from energy price increases is to switch to a fixed rate tariff. This means that for the duration of the deal, the cost of your energy and gas will be fixed. You may be able to switch to a cheaper fixed price tariff at any point, or you may have to pay a fee if you switch before the end of the deal – so check your paperwork.
Excessive Total Harmonic Distortions (THD) and not unity Power Factor (PF) is costly at every level of the electricity market. Cost of PF and THD impact is difficult to estimate, but both can potentially cause heat, vibrations, malfunctioning and even meltdowns. Power factor is the ratio of real to apparent power in a power system. Drawing more current results in a lower power factor. Larger currents require costlier infrastructure to minimize power loss, so consumers with low power factors get charged a higher electricity rate by their utility. True power factor is made of displacement power factor and THD. Power quality is typically monitored at the transmission level. A spectrum of compensation devices mitigate bad outcomes, but improvements can be achieved only with real-time correction devices (old style switching type, modern low-speed DSP driven and near real-time). Most modern devices reduce problems, while maintaining return on investment and significant reduction of ground currents. Power quality problems can cause erroneous responses from many kinds of analog and digital equipment, where the response could be unpredictable.
CenterPoint Intelligent Energy Solutions LLC, IES, which manages TrueCost, is not the same legal entity as CenterPoint Energy Resources Corp. (CERC) or CenterPoint Energy Houston Electric, LLC (CEHE), nor is IES regulated by the Railroad Commission of Texas or the Public Utility Commission of Texas. You do not have to buy products or services from IES in order to continue to receive quality regulated services from CERC or CEHE.
The local electric company is the utility – that’s the company who owns the infrastructure, including the poles and power lines that deliver electricity to your home. They are who you call if your power goes out or there's an emergency. But in almost every city in Texas, you must choose another company to supply that energy, called a Retail Electric Provider (REP). These REPs, like Spark Energy, allow you to choose electricity plans that offer competitive prices and plans to meet your needs.