The inclusion of renewable energy distributed generation and AMI in the modern electricity grid has introduced many alternative rate structures. Simple (or fixed) rate, tiered (or step) rate, TOU, demand rates, tiered within TOU, seasonal, and weekend/holiday rates are among the few residential rate structures offered by modern utilities. The simple rate charges a specific dollar per kilowatt ($/kWh) consumed. The tiered rate is one of the more common residential rate programs, and it charges a higher rate as customer usage increases. TOU and demand rates are structured to help maintain/control a utility’s peak demand. The concept at its core is to discourage customers from contributing to peak-load times by charging them more money to use power at that time.
Ironically, technology can make the utilities’ problem worse, not better—at least in the short term. In the past, grids were developed because it was cheaper to generate large quantities of power and distribute it over wide distances, rather then generate smaller quantities closer to the place of use. It is for this reason that electricity is seen as a business that benefits from “economies of scale”.
Most common distribution network and generation is done with 3 phase structures, with special attention paid to the phase balancing and resulting reduction of ground current. It is true for industrial or commercial networks where most power is used in 3 phase machines, but light commercial and residential users do not have real-time phase balancing capabilities. Often this issue leads to unexpected equipment behavior or malfunctions and in extreme cases fires. For example, sensitive professional analogue or digital recording equipment must be connected to well-balanced and grounded power networks. To determine and mitigate the cost of the unbalanced electricity network, electric companies in most cases charge by demand or as a separate category for heavy unbalanced loads. A few simple techniques are available for balancing that require fast computing and real-time modeling.
Excessive Total Harmonic Distortions (THD) and not unity Power Factor (PF) is costly at every level of the electricity market. Cost of PF and THD impact is difficult to estimate, but both can potentially cause heat, vibrations, malfunctioning and even meltdowns. Power factor is the ratio of real to apparent power in a power system. Drawing more current results in a lower power factor. Larger currents require costlier infrastructure to minimize power loss, so consumers with low power factors get charged a higher electricity rate by their utility. True power factor is made of displacement power factor and THD. Power quality is typically monitored at the transmission level. A spectrum of compensation devices mitigate bad outcomes, but improvements can be achieved only with real-time correction devices (old style switching type, modern low-speed DSP driven and near real-time). Most modern devices reduce problems, while maintaining return on investment and significant reduction of ground currents. Power quality problems can cause erroneous responses from many kinds of analog and digital equipment, where the response could be unpredictable.
Because prices from energy companies in Maryland rise and fall depending on the wholesale price of energy, residents may want a more stable rate for a longer period. A fixed-rate energy plan offers you just that, with a consistent rate for the duration of your agreement at current energy prices – regardless of fluctuations in the energy market. This could mean protection from rate spikes and savings for electric utility customers.
Aside from times of natural disasters and large-scale accidents, electricity prices tend to be steadily dictated by electricity demand. Typically, the price of electricity rises when demand rises. In turn, the lower demand is, the cheaper electricity rates become. This pattern is due to the fact that increased demand requires increased energy production. When extra energy is demanded, utilities are forced to use alternative sources of energy production that may cost more to operate. For example, when electricity demand reaches a high point in Texas, coal plants are used alongside the typical natural gas plants. These coal plants are costlier and less effective than natural gas plants, but are necessary to meet high electricity demand levels.
The table below shows simple comparison of electricity tariffs in industrialised countries and territories around the world, expressed in US dollars. The comparison does not take into account factors including fluctuating international exchange rates, a country's purchasing power, government electricity subsidies or retail discounts that are often available in deregulated electricity markets.
In addition to having a healthy dose of Texas pride, we also pride ourselves on providing friendly customer service. Amigo Energy customer service comes in a variety of convenient ways—from our mobile app and desktop portal, to our US-based call center with over 500 customer service agents. No matter which type of Amigo Energy customer support you choose, you’re sure to get the service you need in the timeframe you want it.
There are a variety of different types of gas and electricity plan that are currently out there for prospective customers to consider. Some plans offer fixed rate deals , these allow you to be sheltered from price rises over an agreed period of time. Other plans allow you to manage your entire account online, making it easier and more efficient for you to handle your energy supply.
It is unlikely that you’ll see any change at all. You will be receiving the same electricity as you always have been, just from a different company. The only difference you definitely will see will be smaller charges for your electricity. By using our price comparison service you’ll be able to cut costs to your energy tariffs and save more money on electricity and gas.
Why are so many African power utilities effectively bankrupt? For one thing, they are incredibly inefficient. Efficiency can be improved by proper metering, investing in the system to reduce losses, improving collections and being able to cut off non-payers. This last one being easier if there is up-to-date metering and certain big players like government departments and military installations are also forced to obey the rules. These operational improvements and efficiencies will improve the supply of power but will not go far enough.
3. Customer service: When the only utility available has lousy customer service, nobody is surprised. They don’t even pretend to care – they know they have you over a barrel. With all these new players in town, however, it’s a slap in the face to be treated like royalty until you’ve signed on the dotted line and now they won’t even return your calls or the person on the phone can’t string three English words together or if he does speak English, he’s brand new and panicking trying to pull up your account information.
Unlike with long-term plans, monthly, variable rate (no-contract) plans have no cancellation fees. You won’t have to pay a penalty if you decide to take your business elsewhere because you found a better deal. Plus, you won’t be left paying more than you should if the market rate for energy trends down. However, if the market prices rise, you’ll have to pay more than those who are in-contract.