Electricity cannot be stored as easily as gas, it is produced at the exact moment of demand. All of the factors of supply and demand will therefore have an immediate impact on the price of electricity on the spot market. In addition to production costs, electricity prices are set by supply and demand. However, some fundamental drivers are the most likely to be considered.
To skirt the late summer electricity rate hikes, a little bit of planning can really pay off. Try to avoid signing new long-term electricity contracts in late summer. While it may be impossible to escape signing a new electricity contract if you’re moving during that time, just know that a short-term plan may make more sense until the rates go back down in the fall. That way you’re not stuck paying a premium rate for an entire year or more.
Using an average of 1,063 kWh of power each month, Houston’s electricity consumption rates exceed the national average by over 100 kWh. As a city however, it does manage to maintain a lower monthly energy charge than the rest of the US, incurring an average fee of $99 in comparison to the $112 national monthly average. To further save on their plans each month, residents can choose from a selection of Texas-based energy suppliers and service plans.
Even though customers in deregulated cities routinely pay more for electricity, there is a bright spot. The gap between the average price paid for electricity between deregulated cities like Houston and regulated cities like San Antonio have dwindled to the narrowest point ever to 8.8 percent. Back in 2006, customers in deregulated cities were paying nearly 47 percent more for electricity than their counterparts in regulated cities.
When you’re choosing a new energy deal, think about whether to go for dual fuel (where you get both your gas and electricity from the same company) or separate tariffs (where you get gas from one company, and electricity from another). It’s worth checking both options, as the combined price of separate tariffs can sometimes be less than a dual fuel offer.
Although conventional long-term contracts may offer you very low kilowatt-hour prices, these contracts also impose many obligations and hefty penalties for non-compliance. No deposit electric plans tend to have a slightly higher energy price that long-term contracts, but allow more freedom in how you pay for your electricity. The most relevant differences between no deposit electricity plans and conventional contracts are summarized in the following table:
The inclusion of renewable energy distributed generation and AMI in the modern electricity grid has introduced many alternative rate structures. Simple (or fixed) rate, tiered (or step) rate, TOU, demand rates, tiered within TOU, seasonal, and weekend/holiday rates are among the few residential rate structures offered by modern utilities. The simple rate charges a specific dollar per kilowatt ($/kWh) consumed. The tiered rate is one of the more common residential rate programs, and it charges a higher rate as customer usage increases. TOU and demand rates are structured to help maintain/control a utility’s peak demand. The concept at its core is to discourage customers from contributing to peak-load times by charging them more money to use power at that time.
A feed-in tariff (FIT) is an energy-supply policy that supports the development of renewable power generation. FITs give financial benefits to renewable power producers. In the United States, FIT policies guarantee that eligible renewable generators will have their electricity purchased by their utility. The FIT contract contains a guaranteed period of time (usually 15–20 years) that payments in dollars per kilowatt hour ($/kWh) will be made for the full output of the system.
The simplest model for day ahead forecasting is to ask each generation source to bid on blocks of generation and choose the cheapest bids. If not enough bids are submitted, the price is increased. If too many bids are submitted the price can reach zero or become negative. The offer price includes the generation cost as well as the transmission cost, along with any profit. Power can be sold or purchased from adjoining power pools.
On the one hand, long-term, fixed-rate (contract) plans offer stability in pricing. If energy supply costs suddenly go up in your area, you won’t be left paying more than what you bargained for. You’ll have peace-of-mind. If you want to switch out of your contract before it ends with a lower cost plan, you’ll likely face a cancellation fee (early termination fee).
It is unlikely that you’ll see any change at all. You will be receiving the same electricity as you always have been, just from a different company. The only difference you definitely will see will be smaller charges for your electricity. By using our price comparison service you’ll be able to cut costs to your energy tariffs and save more money on electricity and gas.
Residents of California paid an average of 19.65 cents per kilowatt hour (kWh) for their electricity in July, one of the highest rates in the country and well above the U.S. average of 13.12 cents/kWh. However, they use an average of 547 kWh per month, well below the U.S. average of 897. That leaves the state with a Choose Energy Price Index score of 92.9, which places it 17th nationally.
Short-term prices are impacted the most by weather. Demand due to heating in the winter and cooling in the summer are the main drivers for seasonal price spikes. In 2017, the United States is scheduled to add 13 GW of natural-gas fired generation to its capacity. Additional natural-gas fired capacity is driving down the price of electricity, and increasing demand.
ElectricityPlans makes shopping for electricity plans simple and intuitive. We give you the search tools you need to narrow your electricity plan search to specific contract lengths. In addition, you can use advanced search to narrow the search for the perfect electricity plan even further by searching for 100% renewable, prepaid plans, or electricity + extra stuff, for example. We also show each plan’s popularity over the past 30 days so you know what other electricity shoppers have selected.
Since consumer demand directly affects energy rates, it’s important to note seasonal trends of demand throughout the year. Overall, demand tends to be higher during the winter and summer months and lower during the fall and spring months. This pattern isn’t shocking since it’s normal for people to require more energy during extreme heat and extreme cold.
Excessive Total Harmonic Distortions (THD) and not unity Power Factor (PF) is costly at every level of the electricity market. Cost of PF and THD impact is difficult to estimate, but both can potentially cause heat, vibrations, malfunctioning and even meltdowns. Power factor is the ratio of real to apparent power in a power system. Drawing more current results in a lower power factor. Larger currents require costlier infrastructure to minimize power loss, so consumers with low power factors get charged a higher electricity rate by their utility. True power factor is made of displacement power factor and THD. Power quality is typically monitored at the transmission level. A spectrum of compensation devices mitigate bad outcomes, but improvements can be achieved only with real-time correction devices (old style switching type, modern low-speed DSP driven and near real-time). Most modern devices reduce problems, while maintaining return on investment and significant reduction of ground currents. Power quality problems can cause erroneous responses from many kinds of analog and digital equipment, where the response could be unpredictable.
The freedom to choose your energy rates in Maryland is not only available in homes but also to commercial customers. In fact, more than 90% of large businesses in the state have enrolled with alternative suppliers. This competition between energy suppliers to provide lower prices for businesses could be why commercial electric prices in Maryland are lower than the national average this year. If the same competition between suppliers existed for residential customers, prices might also decrease. However, without participation in energy choice, suppliers are not forced to compete for your business. Want to see the available rates? Enter your ZIP code above.
Where should you shop for electricity? Houstonians have the power to choose from an overwhelming variety of energy suppliers, plans, and options. If you live in the Houston metro area and your local electric utility is CenterPoint, over 50 different retail electricity providers currently offer electricity plans in your area. Each of these electricity providers offer sites, tools, and information on how to switch plans and providers. However, their information is often filled with electricity rates that are difficult to compare because of things like introductory rates, bill credits, narrow usage levels, unexpected fees, and legalese buried in the EFLs. Fortunately, Houston homes and businesses have electricity shopping options that make the process much simpler.
Keeping on top: With deregulation, a whole host of electric resellers jumped into the market because there’s a whole lot of electricity to sell: if Texas were a country, it’d be the 11th largest electricity consumer in the world! Just by itself, it uses as much electricity as Spain or Great Britain! That means there’s a whole lot of information you have to find, absorb, and process to make sure you’re getting the best rate for your needs.
In Maryland, you have the power to choose your electricity and natural gas suppliers. More than 500,000 Marylanders have already switched energy suppliers. Need a good reason to switch? Some suppliers regularly offer rates and service that are 10% or more cheaper than the utility. Things could get worse - Baltimore Gas and Electric Co. has proposed a rate increase it says would boost the average residential customer's total bill by $5.77 per month. A recent Choose Energy survey found that more than 86 percent say they've never chosen a competitive Maryland electricity plan, meaning they're probably paying more than they have to for energy. Don't pay more. Just enter your ZIP code above to see how you can begin saving with Choose Energy!
Canadian electricity is cheap at 10 US cents per kilowatt hour, which is reflected in their high average electricity usage. US electricity prices at 0.12 $/kWh are also quite cheap internationally. In India and China they are very cheap. The UK is in the middle at 20 cents. It’s relatively expensive globally but not too bad for Europe, where most countries pay a high share of tax on their power.
In summary, fixed-rate plans provide a level of certainty and stability in your energy charge since the price will not fluctuate over the life of your contract. If prices suddenly spike, you are protected because your rate is locked in. The flip side is that if rates drop over the life of your contract, you’ll be stuck paying the higher rate. You can incur steep cancellation fees if you change electricity plans or providers before the end of your contract term.
Texas currently produces and consumes more electricity than any other state in the country. This energy consumption is due to its size, but the ample land makes it a major producer of wind power – a renewable, or green, energy source. The environmentally friendly energy created by wind power is available to many Texas residents to supply the electricity in their home or business.
Fixed-rate plans: Fixed-rate plans give customers more stability for their monthly energy bills because the rate a customer signs up with is the rate he or she pays for the length of the plan’s contract. Most fluctuation comes with usage, though transmission and delivery charges and local fees also can change.. Because a fixed-rate plan sometimes spans two-three years, these plans often require a customer credit check and can include early cancellation fees. Fixed-rate plans, because of the continuing market volatility, probably are the best choice for many consumers.
You can organize and shop by pricing at YOUR individual usage level, which allows you to shop and compare energy plans based on the rates you’ll actually see appear on your bill, inclusive of taxes and hidden fees. You won’t be misled by the “teaser rates” tied with higher usage levels that many homes never experience, as their usage level never reaches that pricing tier.