Prices for any single class of electricity customer can vary by time-of-day called TOU or time of use or by the capacity or nature of the supply circuit (e.g., 5 kW, 12 kW, 18 kW, 24 kW are typical in some of the large developed countries); for industrial customers, single-phase vs. 3-phase, etc. Prices are usually highest for commercial and residential consumers because of the additional costs associated with stepping down their distribution voltage. The price of power for industrial customers is relatively the same as the wholesale price of electricity, because they consume more power at higher voltages. Supplying electricity at transmission-level high voltages is more efficient, and therefore less expensive.
Wind and solar power are non-dispatchable. Such power is normally sold before any other bids, at a pre-determined rate for each supplier. Any excess is sold to another grid operator, or stored, using pumped-storage hydroelectricity, or in the worst case, curtailed. Curtailment could potentially significantly impact solar power’s economic and environmental benefits at greater PV penetration levels. Allocation is done by bidding.
It is unlikely that you’ll see any change at all. You will be receiving the same electricity as you always have been, just from a different company. The only difference you definitely will see will be smaller charges for your electricity. By using our price comparison service you’ll be able to cut costs to your energy tariffs and save more money on electricity and gas.
Most common distribution network and generation is done with 3 phase structures, with special attention paid to the phase balancing and resulting reduction of ground current. It is true for industrial or commercial networks where most power is used in 3 phase machines, but light commercial and residential users do not have real-time phase balancing capabilities. Often this issue leads to unexpected equipment behavior or malfunctions and in extreme cases fires. For example, sensitive professional analogue or digital recording equipment must be connected to well-balanced and grounded power networks. To determine and mitigate the cost of the unbalanced electricity network, electric companies in most cases charge by demand or as a separate category for heavy unbalanced loads. A few simple techniques are available for balancing that require fast computing and real-time modeling.
The UK has been a net importer of energy for over a decade, and as their generation capacity and reserves decrease the level of importing is reaching an all-time high. Their fuel price's dependence on international markets has a huge effect on the cost of electricity, especially if the exchange rate falls. Being energy dependent makes their electricity prices vulnerable to world events, as well.
Anyone on a standard rate tariff is at risk of seeing rising energy bills – so one of the best ways to protect from energy price increases is to switch to a fixed rate tariff. This means that for the duration of the deal, the cost of your energy and gas will be fixed. You may be able to switch to a cheaper fixed price tariff at any point, or you may have to pay a fee if you switch before the end of the deal – so check your paperwork.
Fixed-rate, long-term (contract) plans provide stability in electricity rates. If market energy costs suddenly trend upward where you live, you can rest assured that you won’t have to pay more out of pocket. However, if you want to switch to a different, lower-cost plan before the end of the contract term, you’ll likely have to pay a cancellation or early termination fee.